Online Service: AnyTime: 7*24
Metallurgical ContentReceded Disk ImpellersConical Disk ImpellersTypes of DrivesPaddleshaft DrivePositive Pulp Level ControlInterior DesignImpeller AssemblyAdjustment of ImpellerSpecial Features Receded Disk for the “Sub-A” Machine are built in two types with corresponding wearing plates: Receded Disk and Diffuser Wearing Plates Conical Disk
When used in equipped with impller, then spin the at the time of process should be made in such amanner as not to break up air bubbles that have been plastered
4.The reasonable slurry can minimize the coarse sand precipitation, which is conducive to of coarse particle minerals. 5.This kind of machine is equipped with automatic control device, which is easy to adjust slurry surface. 6. is equipped with upper and lower tilt back blades
· In addition, the behaviors of the pyrolytic active materials which were obtained during industrial production process were studied in a with the pulp density, speed, and aeration during were maintained at 40 g/L, 1800 rpm, and 0.8 L/min, respectively
SF 【Introduction】: SF is a mechanical agitation type equipment with self-slurry suction and self-air suction 【 Capacity 】: 0.37~20m3 【Improvement】: Both sides of the with back rake blades ensures double circulating of slurry inside the tank
Structure and working principle of XJK machine for sale XJK series of machine consists of , , belt pulley, inlet pipe, strobe, covering plate, standpipe, draw bar, etc. When the machine works, the motor drives the to revolve, so the centrifugal effect and negative pressure are produced
In the mechanical flotation cells the feed can be introduced directly to the zone from the side as in a Denver-style Sub A sub-aeration machine. A centrally located paddle-wheel type impeller generates a rotating pulp vortex which extends between two stationary elements: the pipe located at the top of the cell, and the draft tube located at the bottom of the cell
· A study has been done to the effects of and During the performance testing the trials were exposed to metallurgical examining and computerised mineral analysis to establish a size-by-size mineralogy
Rubber and stator, The contact angle may be altered by the addition of reagents prior to the process. Several of these key parameters are influenced by the mixing that occurs within the